Use And Care Manual

Assembly
Unpacking instructions
CAUTION:
Two people are recommended for assembly.
1
After opening shipping box, remove protective cardboard from the top of the wood table and place cardboard on the floor.
With the aid of an assistant, remove wood table and lay topside down on cardboard to protect the wood from scratching.
□
□
Remove the remainder of workbench parts from shipping box. Check parts and hardware against the PARTS and
HARDWARE lists on the next page. If parts or hardware are missing, please call 1-866-441-5080 for assistance.
□
Attaching the Leveling Feet
2
Attach the four Leveling Feet (CC) to the Left (D) and
Right Leg Panels (E) and tighten.
□
6
E
D
CC
3
Workbench Height Adjustment
□ Completely unscrew the Screws (AA) from each
Leg Panel as shown in figure below.
□ Raise or lower the leg bottoms to the same position
in the leg channels on each Leg Panel.
□ Insert and securely tighten the previously removed
□ Ensure 8 Screws (AA) are used to secure the Leg Panels.
screws.
The Leg Panels are pre-set for a total workbench height
of 36 inches (not including leveling feet).
The Leg Panels can be adjusted to alter the workbench
height from 32 inches to 42 inches.
Leg bottom
Leg channel
AA