Use And Care Manual

4. Raise the lower blade guard and use supplied

phillips screwdriver to loosen screw almost 7/32".

(See Figure 3 )

The lower blade guard can be held in the up position

by the screw. Push the locating plate upward.

(See Figure 4 )

Depress the spindle lock (F) to keep the saw blade

from turning.

(See Figure 5 )

7. Use the wrench to unscrew and remove the

spindle bolt.

NOTE: The Spindle bolt unscrews in a clockwise

direction. Then, remove the Outer Flange.

(See Figure 6 )

8. Install a New Blade

Make sure to match the direction arrows marked on the new blade with the direction arrows

marked on the upper blade guard. ( Saw teeth should always be pointing downward. )

Replace outer ﬂange.

Tighten spindle bolt securely,using the blade wrench and tightening counterclockwise.

Rotate lower blade guard back into place,replace any screws that were removed, tighten the

screws that hold the upper and lower guard in place, by tightening in clockwise rotation.

Remove cross pin so the saw can be lowered into cutting position.

Disengage spindle lock.

screw

locating

plate

FIG.5

FIG.4

FIG.3

FIG.6