Use And Care Manual

Page 16
INSTALL EXTENSION BARS
(FIG.4)
Extension bars have been provided for both
the left and the right side of the saw.
1. Remove the screw from the end of the
extension bar.
2. Insert the ends of extension bar into the
holes in the sides of the base.
3. Replace screw and tighten to secure the
extension bar in place.
4. Repeat for the other extension bar.
5. If you want to adjust the extension bar,
you can loosen the locking screw, push
or pull the extension bar to the desired
position, and then tighten the locking
screw.
FIG. 4a
Base
Extension
Bar
Locking
Screw
FIG. 4b
Screws
NOTICE: Remove the locking screws on
the base before installing the extension
bars.
WARNING:
Always use extension
bars to support a long workpiece so it
is level with the top surface of the main
table for an accurate cut and to prevent
dangerous loss of control.
INSTALL THE DUST BAG (FIG.5)
Align the dust bag with the dust port on
the miter saw and then insert the dust bag
onto the dust port. Close the zipper before
operating the miter saw. The dust port also
accepts a standard 1-1/4” (3.2 cm) vacuum
tube for dust collection.
NOTICE: Check bag frequently and empty
it before it gets full. To empty the dust
bag, remove it from the dust port. Open
the zipper on underside of bag and empty
the dust into waste container.
FIG. 5
Zipper
Dust Bag
Dust
Port
OPERATION