Use And Care Manual

Page 28
guard. Make sure that the blade teeth
are pointing downward.
3. Place the outer flange against the blade
and on the arbor. Thread the blade bolt
onto the arbor in a counterclockwise
direction.
4. Place the phillips screwdriver into the
blade bolt.
5. Press the spindle-lock button, holding
it in firmly while turning the blade
counterclockwise. When spindle lock
engages, continue to press it in while
tightening the arbor screw securely.
6. Pull the arbor guard to its original
position until the slot in the arbor guard
engages with the arbor guard screw
(FIG.21a). While holding the lower blade
guard, tighten the arbor guard screw
with a phillips screwdriver (included).
7. Verify that the operation of the lower
blade guard does not bind or stick.
8. Be sure the spindle lock is released so
the blade turns freely before operating
FIG. 22
Outer Flange
Arbor
Shaft
Arbor
Screw
Inner
Flange
Saw
Blade
TRANSPORT THE SAW (FIG.23)
In order to conveniently carry the miter saw
from place to place, a lifting handle has been
included on the top of the saw and hand
indentation at the end cap of sliding rail.
NOTICE: When transporting the miter saw,
the slide rail and the saw head should
always be locked in position.
FIG. 23
Indentation
Lifting
Handle
MAINTENACE