Owner manual

Cat. Nos 217 Series Bulkhead Light Fixtures

INST

ALLATION INSTRUCTIONS

Read all instructions before proceeding.

1). All wiring should be done by a qualified marine electrician in accordance with A.B.Y.C. Standard E-9* and the U.S. Coast Guard Safety Standards for Boat Electrical

Systems (33 CFR 183)*.

2). Using the fixture as template, drill holes in the mounting surface for the mounting screws and for passage of the electric leads. Drill for #6 screws for the 217 series

and #8 screws for the 450 series.

3). Attach supply connections to the pigtail leads on the fixture in accordance with the standards referenced in item No. 1 above.

4). Fasten fixture to mounting surface using #6 R.H. screws..

* The above referenced standards can be obtained from:

(1). American Boat and Yacht Council, Inc. (2). U.S. Coast Guard

3069 Solomon’s Island Road Washington, D.C. 20593

Edgewater, Maryland 21037 (or your local C.G. office)

6/03

PERKO, INC.

16490 N.W. 13th Avenue

Miami. FL. 33169-5707

www.perko.com

Summary of content (1 pages)

PAGE 1
Cat. Nos 217 Series Bulkhead Light Fixtures INSTALLATION INSTRUCTIONS Read all instructions before proceeding. 1). All wiring should be done by a qualified marine electrician in accordance with A.B.Y.C. Standard E-9* and the U.S. Coast Guard Safety Standards for Boat Electrical Systems (33 CFR 183)*. 2). Using the fixture as template, drill holes in the mounting surface for the mounting screws and for passage of the electric leads. Drill for #6 screws for the 217 series and #8 screws for the 450 series.