Owner's manual

Item Description Qty.
1-7 Front Ring (7”)1 1-8 Front Ring (8”)1 2-7 Housing Assembly (7”)1 2-8 Housing Assembly (8”)1
3 Label, Perko 1 4 Screw (Rear Cover Retainer) 4
5-7 Back Cover (7”)1 5-8 Back Cover (8”)1
6 Gland 2 7 Cord Assembly 1 8 Drum Bracket 1 9 Screw (Drum Bracket Retainer) 4
10 Nut (Drum Bracket Retainer) 4
11 Lock Washer (Star Type) 4
12 Pivot Bar 1
13-7 Sealed Beam (7” Head) 1 13-8 Sealed Beam (8” Head) 1 14-8 Resistor Assembly (not shown) 1 15-7 Bushing (7” Bulb Support) 4 16-7 Screw (7” Bulb Support Retainer) 4 17-8 Bulb Bracket (Used on 8” Only) 3 18-8 Rivet (Bracket Retailner 8” Head) 3
19 Rubber Boot 1 20 Lock Nut 1 21 Bushing (Control Rod) 1 22 Split Bushing (Control Bracket) 1 23 Stop Collar 1 24 Fulcrum Strap 1 25 “Cone Point” Set Screw 6 26 Control Bracket 1 27 Set-Screw (Lock Nut Retainer) 1 28 Base Assembly 1 29 Gasket 1 30 Ceiling Plate 1 31 Control Rod 1 32 Set-Screw (“Dog Point”)2 33 Split Bushing (Fulcrum) 1 34 Knob Assembly 2 35 Nut, Control Rod 1 36 Yoke 1 37 Pivot Bearing 1 38 Handle Rod 1 39 Roll Pin 1 40 Control Handle 1 41 Fulcrum 1 42 Screw (Front Ring Retainer) 1
Bill of Materials
16490 N.W. 13th Avenue Miami, FL 33169-5707
Scale: None Date: 3/7/97
Revised: 5/21/97 Drawn By: Hassan
Fig. 314 Searchlight Assembly (7” & 8”)
FIG. 314 - 7 INCH & 8 INCH
SEARCHLIGHT ASSEMBLY
Table 1 - Sealed Beam Numbers
12V Nom 24V Nom 32V Nom
7” 4543 4541 200 Par56 8” 4715 4559 4559*
* Used in conjunction with resistor (Item#14-8)
S
I
Z
E
Table 2 - Sealed Beam Specifications
Bulb No. V Nom WABCP 4543 12 100 8.5 250,000 4541 24 450 19 470,000 200 Par 56 32 200 6.5 260,000 4715 12 250 21 500,000 4559 24* 600 25 600,000
* Also used for 32 Volt System in conjunction with a resistor.
(32V, 600W, 19A, 600,000 B.C.P.)