Owner manual

"
Fig. 0675 Series
Post Type Strike
APPROXIMATE
LOCATION OF THE
EDGE OF HATCH
Drill 2 Inch Hole
Leave template flat
to position the strike
then drill along this
line on underneath
of deck surface for
#8 Screw
MOUNTING TEMPLATE FOR POST TYPE STRIKE
1-1/2” Min
1-3/4” Max
1-1/2”
to
1-3/4”
MOUNTING INSTRUCTIONS
These latches are designed to be mounted through surfaces from
1/8 inch to 3/4 inches thick.
1). Cut out the appropriate template below.
2). Lay on hatch (flat) to determine the relative locations of the
strike
3). Mark center of hole for drilling, then drill a 2 inch hole
through the mounting surface.
4). Insert latch through the hole in the surface and attach
back-up nut.
5). For Post T
ype Strike:
Mark and drill for a #8 screw near the edge of the hatch in
order to engage with the teeth on the slide. Note the
mounting distance between the center of the latch and the
center of the strike (1-1/2” to 1-3/4”).
6). For Flat Strike:
After making sure the vertical surface is in the range
(1-11/16” to 1-13/16”) per the template, place strike on the
surface and drill for two #8 screws
MOUNTING ILLUSTRATION - POST TYPE STRIKE
Fig. 0675 Series
Flat Strike
APPROXIMATE
LOCATION OF THE
EDGE OF HATCH
Drill 2 Inch Hole
Leave template flat to position the
vertical surface (which mounts the strike)
between the broken lines.
MOUNTING TEMPLATE FOR FLAT STRIKE
1-11/16”
to
1-13/16”
Latch Assembly
Mounting
Gasket
Back-up Nut
Post Strike
MOUNTING DIAGRAM
Cat. No. 0675 Series Slam Latch
Patent Pending
PERKO, Inc.
16490 N.W. 13th Ave
Miami, FL 33169-5707
www.perko.com
08/04
0675INS1
MOUNTING ILLUSTRATION - FLAT STRIKE
1-11/16” Min
1-13/16”
Flat Strike