Instructions / Assembly

See our full line of Perky-Pet

birdfeeders and accessories at www.perkypet.com

855-757-5973 | Woodstream Corporation | 69 N. Locust Street Lititz, PA 17543, USA

Instructions:

1. Remove sticker.

2. Remove end cap.

3. Using your index ﬁnger, bring cord eyelet through open side of bar. Once inside the bar, slide

the eyelet, loop side up, through the bottom of hole. Once you hear the clock, twist adapter

180 degrees to secure into position.

4. Repeat step three on opposite end.

5. Replace end caps.

6. Take the loose end of an adjustable hanging cord and put it through the eyelet’s loop hole.

Then, squeeze the cord lock to create an opening. Feed the loose end of the cord through the

opening and once the loose end of the cord is through the cord lock, release your grip. This

action will secure the hanging cord to the bar.

7. Repeat step six on the opposite end.

8. Select an outdoor location to hang the Hummerbar® . The Hummerbar® must be hung from

two points, 90 degrees above cord eyelets. We recommend hanging from two shepard’s hooks

or from two hooks on a porch awning. Place in a shaded area with low winds.

Disassembly and cleaning instructions:

1. Remove Hummerbar® by carefully removing

hanging cords from hooks. Keep feeder level.

2. Remove end caps and rinse with warm soapy

water. We recommend using the Perky-Pet®

Cleaning Mop to clean individual ports and

the tube.

3. We recommend washing your

Hummerbar® twice a week.

4 ft Hummerbar

Model #HUMBAR400

Adjustable hanging cord

Cord lock

Rubber stopper

Funnel

Cord eyelet

End cap