Adaptors User Guide

UltraPort Serial Adaptors User Guide
SCO UnixWare/SCO OpenServer 6
Page 146
SCO UnixWare error messages
Error message Reason Action required
ERROR: unit @0xnnnnnnnn has
bad resource(s)
Incorrectly installed or faulty
card.
Incorrect BIOS settings.
1. Ensure that you have followed the
installation procedure correctly.
See page 64.
2. Check BIOS settings.
3. If the problem persists try another card.
See page 64 and page 95.
ERROR: unit @0xnnnnnnnn not
mapped
Insufficient memory available
to kernel.
Reconfigure system/kernel memory
parameters.
ERROR: unit @0xnnnnnnnn not
initialised
Incorrectly installed or faulty
card.
1. Ensure that you have followed the
installation procedure correctly.
See page 64.
2. If the problem persists try another card.
See page 64 and page 95.
WARNING: unit @0xnnnnnnnn not
configured
System error. 1. Uninstall the driver and remove all
Speed cards from the system.
See page 64
2. Re-install the driver and cards taking
care to follow the correct procedure.
See
page 64 and page 95.
Error: could not register interrupt
handler for unit @0xnnnnnnnn
System error 1. Uninstall the driver and remove all
Speed cards from the system.
See page 64
2. Re-install the driver and cards taking
care to follow the correct procedure.
See
page 64 and page 95.
WARNING: No Speed ports
configured
No cards installed.
Installed cards suffer from
one or more of above
symptoms.
1. Install cards. See page 95.
2. Resolve any above listed faults.