User manual

UltraPort Serial Adaptors User Guide
Installing under Windows 95 and 98
Page 19
Chapter 2 Installing drivers and host cards
General installation procedure for Windows 95 and 98
The general procedure for installing UltraPort and UltraPort SI only cards under the Windows
95/98 operating systems is as follows:
1. Install any UltraPort and UltraPort SI cards and cables or connector boxes you require
into your system. See
Installing host cards and cable accessories on page 94.
2. Using the Windows Found New Hardware Wizard, install the UltraPort or UltraPort SI
device driver software. See
Installing device drivers and utilities on page 20
3. If required, remove any host cards you want from your system. See Removing host
cards on page 100.
4. Using the Windows Device Manager, configure the serial ports you have added to the
system. See
Configuring serial ports on page 24.
Note
The UltraPort and UltraPort SI device drivers for Windows 95/98 are
not included on your Windows 95 or Windows 98 CDROM.