User Guide

ManualsBrandsperle Manualsrouterperle IRG5410 Series Router

IRG5410 Series Router Quick Start Guide 5500448-10 (Rev B)

Version #A04.23.2020

IRG5410 Series Router

Quick Start Guide

_____________________________________

This guide covers basic installation and configuration and is

intended for first time setup or product evaluation. The

models covered by this guide are the IRG5410 and

IRG5410+.

Complete details can be found in the following guides at

www.perle.com/downloads.

• IRG5410 Series Router Hardware Installation Guide

• IRG5000 Series Router User’s Guide

• IRG5000 Series Routers Command Line Reference

Guide

What’s in the box?

• IRG5410/5410+ Router

• IRG5410 Series Routers Quick Start Guide (this guide)

• GPIO Cable with 4 pin plug (#2500468)

• GPIO Cable with 8 pin plug (#2500476)

• 12VDC/2A power supply 4 pin (NA #08000150),

EU#08000160, UK #08000170)

• 2 LTE antennas (#08000120)

• Optional – GNSS PASV RP-Antenna SMA/CA

(#08000130) passive or active antenna

• Optional – DIN Rail mounting kit (orderable from Perle)

Summary of content (4 pages)

PAGE 1
IRG5410 Series Router Quick Start Guide _____________________________________ This guide covers basic installation and configuration and is intended for first time setup or product evaluation. The models covered by this guide are the IRG5410 and IRG5410+. Complete details can be found in the following guides at www.perle.com/downloads.
PAGE 2
Note: these components may be included with your product. Components may vary depending for each model. See the Perle website for updates. Getting Started The steps for a typical installation are: 1. Inserting the SIM card/s. 2. Connecting antenna/s. 3. Connecting the Power. 4. Connecting to the Cellular Network. 5. Fast Setup Mode. Inserting the SIM cards Use only mini-SIM (2FF) cards. Ensure the power is disconnected before you insert the SIM card/s. 1.
PAGE 3
Connecting the Antennas 1. Connect your cellular antenna to connector Main. 2. Connect the diversity antenna to connector Diversity. 3. Connect your GPS antenna to connector GNSS. See Figure 2 Connecting the Power See Figure 2 for wiring requirements. Colors indicated are for the Perle supplied DC cable. Connecting to the Cellular Network When the router is powered on, it begins the process of activation and attempts to connect to the cellular network. This process typically takes a few minutes.
PAGE 4
Fast Setup Mode Fast Setup provides a simple method of doing an initial setup from a PC. Your router is shipped in factory default mode. 1. 2. 3. 4. 5. Your PC must be set to obtain an IP address automatically using DHCP. Plug the PC into your router’s Ethernet interface. When the Power LED is flashing green, use a web browser, enter http://192.168.0.1 to access your router. On the setup screen, select, Getting Started. Once connected, fill in the required fields, apply changes to save and exit.