Installation Instructions

PERLICK RESIDENTIAL INSTALLATION MANUAL
10
perlick.com
8). Remove the Perlick nameplate from the door front
using a plastic putty knife (Fig. 12). Install the new Perlick
nameplate included in the kit.
Nameplate
9). Insert the bearing into the door hinge bracket (Fig. 13).
10). Insert the V-block into the door bottom hinge bracket
and attach with the e-clip (Fig. 13). Note the orientation of
the V-block.
Bearing in
door top hinge
bracket
Door bottom bracket
V-block
6°
BOTTOM VIEW
Orientation
11). Attach the top and bottom hinges and push plunger
using screws removed in step 6 (Fig. 14).
Top hinge
and screws
Bottom hinge
and screws
Front panel
Corner screws need not be
removed to remove front panel
7). Remove the front panel from the door assembly by
removing the inner mounting screws, 4 per side, from the
perimeter of the door assembly (Fig. 11). Rotate the front
panel 180°. The top becomes the bottom. Reattach using
the same screws and mounting holes.
Figure 11. Removing Front Panel
Figure 12. Nameplate
Figure 13. Bearing and V-Block
Figure 14. Door Hinges