Use and Care Guide All Models HP15 HP24 HP48 HC24 HA24 HH24 15” SIGNATURE SERIES 24” SIGNATURE SERIES 48” SIGNATURE SERIES C-SERIES ADA-COMPLIANT SERIES SHALLOW-DEPTH SERIES Form No. Z2344 Rev. 04.01.
PERLICK RESIDENTIAL INSTALLATION MANUAL TABLE OF CONTENTS Warranty Information ..................................................................2 Outdoor Model Start-Up/Winterizing................................7 Safety Information..........................................................................4 LED/Light Bulb Replacement..................................................7 Operation.............................................................................................
PERLICK RESIDENTIAL INSTALLATION MANUAL REMEDY: Perlick will provide the parts and labor necessary to repair or replace (at Perlick’s option) any parts proven to be defective in material or workmanship during the Basic Warranty Period. Perlick will provide the replacement parts, but not the labor, for any parts of the hermetically sealed refrigeration system proven to be defective in materials or workmanship during the Extended Warranty Period.
PERLICK RESIDENTIAL INSTALLATION MANUAL SAFETY PLEASE READ all instructions completely before attempting to install or operate the unit. Take particular note of the DANGER, WARNING and CAUTION information in the manual. The information is important for the safe and efficient installation, operation and care of your Perlick unit. DANGER Indicates a hazard that WILL result in serious injury or death if precautions are not followed.
PERLICK RESIDENTIAL INSTALLATION MANUAL Signature Series Dual-Zone Control Instructions Upper Compartment: To view the upper compartment temperature, press and release the DEFROST button (melting snowflake). Lower Compartment: Display reading always shows the lower compartment temperature. Setpoint Display: Press and release the SET button; display will read St1. Press SET again and the LOWER compartment setpoint will be displayed. Press SET again; the display will read St2.
PERLICK RESIDENTIAL INSTALLATION MANUAL Max Temp Set Factory Temp Setpoint HP15R 30° F 42° F 38° F HP15B 30° F 48° F 42° F HP15W 40° F 68° F 45° F HP15T 30° F 42° F 38° F Min Temp Set Max Temp Set Factory Temp Setpoint HP24R 30° F 42° F 38° F HP24F -10° F 10° F 0° F HP24B 30° F 48° F 42° F HP24W 40° F 68° F 45° F HP24T 30° F 42° F 38° F Min Temp Set Max Temp Set Factory Temp Setpoint - 10° F 10° F Freezer - 0° F 30° F 42° F Refrigerator - 38° F HP48RR 30°
PERLICK RESIDENTIAL INSTALLATION MANUAL MAINTENANCE SEASONAL MAINTENANCE FOR UL-APPROVED OUTDOOR MODELS Winterizing This process should occur when the daily low temperatures is at or below the temperatures stated below: Freezer models: 32° F Refrigerator models: 38° F Beverage Center: 42° F Wine Reserve: 45° F It is best to winterize your unit before the low temperatures listed above. 1. Turn the unit to OFF position by pressing the OFF button on the controller.
PERLICK RESIDENTIAL INSTALLATION MANUAL STAINLESS STEEL CARE & CLEANING General Stainless steel is a “passive” metal because it contains other metals like chromium, nickel and manganese that stabilize the atoms. Chromium provides an invisible passive film that covers the steel surface, acting as a shield against corrosion. As long as the film is intact and not contaminated, the metal is passive and stainless. If the passive film of stainless steel has been broken, equipment can start to corrode and rust.
PERLICK RESIDENTIAL INSTALLATION MANUAL Recommended Cleaners for Specific Situations Job Cleaning Agent Comments Routine cleaning Soap, ammonia, detergent Apply with sponge or soft cloth Fingerprints and smears Areal 20, Lac-O-Nu, Lumin Wash, O-Cedar Cream Polish Provides barrier film to minimize fingerprints. Can be used on all finishes. Rub the surface with a cloth as directed on the package.
PERLICK RESIDENTIAL INSTALLATION MANUAL TROUBLESHOOTING DANGER If the unit appears to be malfunctioning, read through the OPERATION section of this manual first. If the problem persists, check this troubleshooting section to see if you can refer to the cause and remedy of the problem and resolve it without a service call.
PERLICK RESIDENTIAL INSTALLATION MANUAL Problem Compartments are warmer than usual Cause Solution Control preset is set to warm • Lower the setpoint temperature. Refer to changing the set point for the specific model Light is staying on • Turn the manual light switch off. Condenser is dirty or obstructed • Clean the condenser and clear obstruction. The door is open or has been opened more frequently lately. • Wait 24 hours and recheck the temperature.
Quality & Innovation that inspires Form No. Z2344 Rev. 04.01.
