Manualshelf

Tap Installation Instructions

ManualsBrandsPerlick ManualsBeer Coolers & Kegerators24 Inch Built-in Beer Dispenser with 1 Quarter-Barrel or 2 Sixth-Barrel Capacity, 525-BTU Compressor and Digital Temperature Control: Panel Ready, Left Door Swing, Single Faucet
12345678910
PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT
10 | perlick.com/residential
Before tapping, make sure the beer faucet is closed. To tap a
keg, insert the coupler into the neck of the barrel. Turn the
coupler clockwise unl it stops (about an 1/8 turn), then push
down on the top of the coupler and again turn clockwise unl
it stops. Your barrel is now tapped. Open the CO2 valve on the
regulator as well as the valve on the manifold if used.
13.
CONNECTING THE REGULATOR TO THE CO2 CYLINDER
1. Remove the blue plug from the regulator ng, but do not
remove the carbonic washer.
2. Screw regulator onto gas cylinder valve. Tighten with wrench
unl vercally straight. Be sure that the shut-o valve on the
regulator is in the OFF (horizontal) posion.
3. Place screw clamp over the end of red line and push onto
regulator tail piece. Tighten clamp with a screwdriver.
4. Turn regulator adjusng screw counterclockwise unl it turns
freely.
5. Turn hand valve counter-clockwise on the CO2 cylinder to
the fully open posion.
6. Turn regulator adjusng screw clockwise unl desired
pressure is reached (approximately 12-15 lbs.) Tighten stop
nut on adjusng screw.
7. Open shut-out valve on boom of regulator.
8. Dilute a small amount of liquid dishwashing soap and rub
the soapy mixture around connecons. If bubbles appear,
ghten connecon.
INSTALLATION