Tap Installation Instructions

PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT
perlick customer service (800)558-5592 | 5
2. Remove air “T” from end of air tube by loosening fastener holding the two halves together. Remove the air tube from the
tower being careful not to damage the product tube.
3. Cut air tube at mark made in step 1. Re-install air tube into tower and re-install “T” on the end of the air tube so “T” faces the
rear of the tower.
4. Cut product tube 3 inches below the “T” and install included barbed union into product tube and clamp using worm drive
clamp.
Figure 3.
Figure 4.
INSTALLATION