Manualshelf

Tap Installation Instructions

ManualsBrandsPerlick ManualsBeer Coolers & Kegerators24 Inch Built-in Beer Dispenser with 1 Quarter-Barrel or 2 Sixth-Barrel Capacity, 525-BTU Compressor and Digital Temperature Control: Panel Ready, Left Door Swing, Single Faucet
12345678910
PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT
6 | perlick.com/residential
Locate the dispensing head , black beer line(s), and hose
clamp(s). Slide one end of each beer line onto the stainless
steel tubes which protrude out the boom of the dispensing
head and clamp ght.
Remove transit tape with a ulity knife around the hole in the
top of the unit from both inside and outside of the cabinet.
Gently punch out foam w/screwdriver and remove. Insert the
beer line(s) through the hole in the counter top. Move head
aside and bead silicone around perimeter of hole, and then
posion the head back in place. Fasten using the 4 chrome
screws included with the dispensing head. Wipe o excess
silicone to complete the seal.
1.
2.
Use the 3/8” -thick foam pad included in the tapping kit and
roll into a cylinder. From inside the cabinet, insert the foam
tube up through the hole in the counter top unl it is rmly
against the insulaon in the dispensing head. Mark, then cut
away any excess foam.
NOTE: If using an Adara tower, foam needs to be installed so
that it is pressed up against the boom mounng ange of
the tower.
3.
INSTALLATION