Tap Installation Instructions

PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT
perlick customer service [phone] | 9
Locate the beer faucet(s) and install onto the dispensing head
shanks. Tighten with supplied spanner wrench. Install black
handle(s) onto faucet(s).
12.
On the right rear sidewall there is a double column of screws.
Remove the le screw. Locate the safety chain and a #10 x
1/2” sheet metal screw from the parts bag. Insert the screw
through the closed end link of the chain and ghten in the
vacant screw hole. The chain can now be used to secure the
tank with “S” hook, prevenng damage to the regulator.
CO2 tanks are shipped empty and must be lled prior to
use. Turn the adjusng knob on the regulator counter-
clockwise unl the secondary gauge (top) reads zero.
Make sure that the valve at the boom of the regulator
where the red hose is connected is in the o posion as
shown. Watching the secondary pressure gauge, turn the
regulator adjusng knob clockwise unl the pressure is at
15 psig. Adjustments can later be made based on ow rates.
IMPORTANT: All pressure adjustments MUST be made when
the shut-o valve is in the OFF posion!
10.
11.
INSTALLATION