Installation Instructions

PERLICK RESIDENTIAL INSTALLATION MANUAL
10
perlick.com
8). Remove the Perlick nameplate from the door front
using a plastic putty knife (Fig. 12). Install the new Perlick
nameplate included in the kit.
Nameplate
9). Insert the bearing into the door hinge bracket (Fig. 13).
10). Insert the V-block into the door bottom hinge bracket
and attach with the e-clip (Fig. 13). Note the orientation of
the V-block.
Bearing in
door top hinge
bracket
oor botto bracke t
 bock

B  
rientation
11). Attach the top and bottom hinges and push plunger
using screws removed in step 6 (Fig. 14).
Top hinge
and screws
oo hinge
and screws
Front panel
Corner screws need not be
removed to remove front panel
7). Remove the front panel from the door assembly by
removing the inner mounting screws, 4 per side, from the
perimeter of the door assembly (Fig. 11). Rotate the front
panel 180°. The top becomes the bottom. Reattach using
the same screws and mounting holes.
Figure 11. Removing Front Panel
Figure 12. Nameplate
Figure 13. Bearing and V-Block
Figure 14. Door Hinges