Use & Care Guide

perlick customer service [phone] | 3
PERLICK RESIDENTIAL UNDERCOUNTER USE & CARE GUIDE
IMPORTANT!
Read and understand all information in this manual before attempting the installation. All plumbing
and electrical work must be performed by a qualied technician and conform to all applicable state
and local codes.
SAFETY
PLEASE READ all instructions completely before
attempting to install or operate the unit. Take particular
note of the DANGER, WARNING and CAUTION information
in the manual. The information is important for the safe
and ecient installation, operation and care of your Perlick
unit.
DANGER
Indicates a hazard that WILL result
in serious injury or death if
precautions are not followed.
W ARNING
Indicates a hazard MAY cause
serious injury or death if
precautions are not followed.
CAUTION
Indicates a hazard where minor
or moderate injury may occur if
precautions are not followed.
NOTICE
Indicates that property damage
may occur if warnings or
instructions are not followed.
Refrigerant
DANGER
Take caution when handling,
moving and using the product to
avoid damaging the refrigerant tubing or increasing
the risk of a leak
WARNING
All service work shall be
performed by factory authorized
service personnel and all component parts shall be
replaced with like components to minimize the risk of
possible ignition due to incorrect parts or improper
service.
CAUTION
If service is necessary, repair work
must be performed by a Perlick
authorized servicer. Work done by unqualied
individuals could potentially be dangerous and will
void the warranty.
N OTICE
This product contains blown foam
insulation using blowing agent
R-611 (Methyl Formate). The foam in this product
does not contain HFC’s, CFC’s, or HCFC’s.
All models covered in this user manual are manufactured
using refrigerant R600a (Isobutane). R600a is a hydrocarbon.
This refrigerant is ammable and is only allowed for use in
appliances with fulll the requirements of UL/IEC 60335-1
and UL/IEC 60335-2-24. (To cover potential risk originated
from the use of ammable refrigerants). Consequently,
R600a is only allowed to be used in refrigerating appliances
with are designed for this refrigerant and fulll the above-
mentioned standard.
• R600a is heavier than air. The concentration will always
be highest at the oor level.
• The explosion limits are as follows:
o Lower Limit: 1.8% by volume
o Upper Limit: 8.4% by volume
o Ignition Temperature: 460°C
Prior To Installation
Carefully inspect cabinet for hidden damage. If damage is
discovered, le your claim immediately with the transport
company. Perlick is not responsible for damage in transit.
CAUTION
When moving the unit, be sure to
protect nished ooring with ap-
propriate material to avoid damage from moving the
unit.
CAUTION
Do not lift unit by drawer, shelving
or door handles, as damage to the
unit could occur if not moved as instructed.
WARNING
To prevent personal injury, a mini-
mum of two people are required to
lift the unit. Larger units may require additional per-
sonnel.
Before moving the unit, secure the door shut with tape
to prevent door from swinging open while being moved.
Carefully move unit to installation site and place in front
of opening.
CAUTION
If unit has been laid on its back or
sides, place unit upright and allow
minimum of 24 hours before connecting power.