Tap Installation Instructions

PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT

8 | perlick.com/residential

If installing a two faucet system, a CO2 manifold will need to

be installed. Locate the red CO2 lines, CO2 manifold and a

#10 x 1/2” sheet metal screw. Slide one end of each hose onto

the barbed ttings on the manifold and clamp. On the left

rear side wall of the beer compartment there is a double row

of screws which run vertically. Remove one of the two top

screws and discard. Insert the sheet metal screw through the

manifold and into the hole vacated previously.

On a single beer system, locate the red CO2 hose. Slide one

end onto the barbed tting of the regulator assembly and

clamp. On systems with two beers, locate the CO2 line that

comes o the backside of the manifold assembly. Slide the

hose onto the barbed tting of the regulator assembly and

clamp. For detailed information on connecting the regulator

to the CO2 cylinder, see page 10.

Locate the low prole keg coupler(s). Slide one of the red

CO2 lines onto the larger barbed tting of coupler and clamp.

Locate one of the black beer lines and slide onto the smaller

barbed tting of the coupler and clamp. Repeat for additional

couplers.

Note: This unit comes standard with

Perlick’s new 304SS Lo-Boy coupler

(40030SSLD)

INSTALLATION