Manualshelf

Installation Sheet

ManualsBrandsPerlick ManualsKegeratorsPerlick 24 Inch Wide 5.2 Cu. Ft. Capacity Beer Kegerator with Dual Taps and RAPIDcool Forced-Air Cooling System from the 24" Signature Series (Left Hinged)
11121314151617181920
PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT
6
perlick.com
Locate the dispensing head , black beer line(s), and
hose clamp(s). Slide one end of each beer line onto the
stainless steel tubes which protrude out the bottom of
the dispensing head and clamp tight.
Remove transit tape with a utility knife around the hole
in the top of the unit from both inside and outside of
the cabinet. Gently punch out foam w/screwdriver and
remove. Insert the beer line(s) through the hole in the
counter top. Move head aside and bead silicone around
perimeter of hole, and then position the head back
in place. Fasten using the 4 chrome screws included
with the dispensing head. Wipe o excess silicone to
complete the seal.
1.
2.
Use the 3/8” -thick foam pad included in the tapping kit
and roll into a cylinder. From inside the cabinet, insert
the foam tube up through the hole in the counter top
until it is rmly against the insulation in the dispensing
head. Mark, then cut away any excess foam.
NOTE: If using an Adara tower, foam needs to be installed
so that it is pressed up against the bottom mounting ange
of the tower.
3.