Installation Sheet

perlick.com

PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT

Insert end of the snorkel up into the tower and screw

air scoop mounting bracket into vacated holes above

the fan.

Install the Air Scoop Kit. Start by removing the upper set

of screws located above the fan on the back wall of the

cabinet.

Assemble components from the kit as follows – Insert

black snap bushing into air scoop mounting bracket,

then insert one end of the air snorkel through the snap

bushing. A zip tie can be inserted behind the mounting

bracket to keep the tube in place.

NOTE: For Adara Towers, the air snorkel consists of a 3 inch

piece of black tubing and a 3 inch piece of clear tubing that

slides over each other and then is clamped using included

worm drive clamp. The black tube is inserted per the above

instructions and secured with the included zip tie. The

clear tube is installed over the air “T” from the dispensing

head and secured with the included worm drive clamp. See

Figure 4 on page 5 for illustration.