Installation Sheet

PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT

perlick.com

If installing a two faucet system, a CO2 manifold will

need to be installed. Locate the red CO2 lines, CO2

manifold and a #10 x 1/2” sheet metal screw. Slide

one end of each hose onto the barbed ttings on the

manifold and clamp. On the left rear side wall of the

beer compartment there is a double row of screws

which run vertically. Remove one of the two top screws

and discard. Insert the sheet metal screw through the

manifold and into the hole vacated previously.

On a single beer system, locate the red CO2 hose.

Slide one end onto the barbed tting of the regulator

assembly and clamp. On systems with two beers, locate

the CO2 line that comes o the backside of the manifold

assembly. Slide the hose onto the barbed tting of the

regulator assembly and clamp. For detailed information

on connecting the regulator to the CO2 cylinder, see

page 10.

Locate the low prole keg coupler(s). Slide one of the

red CO2 lines onto the larger barbed tting of coupler

and clamp. Locate one of the black beer lines and slide

onto the smaller barbed tting of the coupler and clamp.

Repeat for additional couplers.