Tapping Installation Manual

PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT
2 | perlick.com/residential
CONGRATULATIONS
Congratulations on your purchase of a Perlick high quality
residential Beer Dispenser. Perlick has proudly manufactured
beer dispensing systems for over 50 years for bars, restaurants,
stadiums, arenas and large venues around the world. That same
technology is used in each and every residential beer dispenser
we produce, assuring you’ll pour fresh, cold beer as the brewery
intended it to be enjoyed.
All Perlick products are built with commercial grade stainless
steel, providing you with the beauty and durability for a lifetime
of use. This installation guide will show you how to properly
install the dispensing equipment on your Perlick Beer Dispenser.
We dedicate considerable time to ensure that our products
provide the highest level of customer satisfaction. If, however,
service is required, call Perlick at 800.558.5592. For your own
protection, never return merchandise for credit without our
approval.
We thank you again for selecting a high quality Perlick Beer
Dispenser. Cheers!
C
US
IMPORTANT!
The installation of the actual beer
dispenser cabinet should happen prior
to installing the dispensing equipment.
Refer to the Installation Manual that
accompanied the Beer Dispenser for
step-by-step installation of the cabinet.
DANGER
Keep CO2 cylinder away from heat.
Rupture disc vents at 122°F
maximum.
DANGER
Do not drop or throw regulator or
CO2 cylinder.
CAUTION
Allow only properly trained and
experienced personnel to handle
high pressure gas.
CAUTION
Do not apply oil to the regulator!
PLEASE NOTE
The following instructions are for both the Draft Arm
(standard tower) and the Adara Signature Beer Tower.
Some photos and drawings may only show the Draft
Arm, but the instructions will also apply to the Adara
Signature Beer Tower unless noted.
INTRODUCTION