User Manual

Appendix C – CAL 3300 Temperature Controller Configuration
1 For all Micro-GASS systems with the CAL3300 Temperature controller, perform the following
setup procedures.
a Power Up - Apply power to the system and wait for the controller to perform its self test
routine. The display will then be alternately flashing “nonE” and “inPt”.
b Input sensor type - Press and hold º key. Press S key repeatedly to select the “tc K”
option for K type thermocouple. Release both keys.
c Input unit type - Press the S key once. The display will then be alternately flashing “unit”
and “nonE”. Press and hold the º key. Press S key repeatedly to select the “
O
C” unit.
Release both keys.
d Input setpoint 1 type - Press the S key once. The display will then be alternately
flashing “SP1.d” and “nonE“. Press and hold the º key. Press S key once to select the
output device ”SSd”. Release both keys.
e Input the maximum temperature setpoint - Press and hold the T key until “LEVL”
appears. Press and hold the º key. Press the T key to move to level 2. Release the two
keys. Press and hold the S key until “hi.SC” appears. Press and hold the º key. Press
the T key until “65” appears. Release the two keys.
f Input the minimum temperature setpoint Press the S key once. “Lo.SC” appears.
Press and hold the º key. Press the S key until “45” appears. Release the two keys.
2 Configure the low temperature alarm.
a Configure SP2 relay as alarm - Press and hold S and T keys simultaneously for 3
seconds to enter the program mode. Release the two keys. The display will then be
alternately flashing “tunE” and “oFF”. Press the T key once. The display will then be
alternately flashing “LEVL” and “1”. Press and hold the
º key. Press the S key once to
move to level 2. Release the two keys. Press and hold the S key until “SP2.A” appears.
Press and hold the º key. Press the S key until the display reads FS.Lo. Release the two
keys. The display will then be alternately flashing “SP2.A” and “FS.Lo”.
b Save configuration into memory - Press and hold S and T keys simultaneously for 3
seconds. The display will then be alternately flashing the process temperature and “PArK”
indicating that no setpoint temperature has been entered.
3 Set the control setpoint and auto-tune the controller.
a Input the control setpoint temperature - Press and hold the º key. Hold the S key until
the display goes from 0 to 65.
b Auto-tune the controller - Press and hold S and T keys simultaneously for 3 seconds to
enter the program mode. Release the two keys. The display will then be alternately
flashing “tunE” and “oFF. Press and hold the º key. Press the S key until “At.SP”
appears. Release the two keys. Press and hold S and T keys simultaneously for 3
21