Specification Sheet

Toll Free: 87 PERMATEX
(877-376-2839)
10 Columbus Blvd., Hartford,
Connecticut 06106
6875 Parkland Boulevard, Solon
Ohio 44139
Technical Data Sheet
Permatex

Ceramic Extreme
Brake Parts Lubricant
AAM Revised 05//08
NOT FOR PRODUCT SPECIFICATIONS.
THE TECHNICAL DATA CONTAINED HEREIN ARE INTENDED AS REFERENCE ONLY.
PLEASE CONTACT PERMATEX, INC., TECHNICAL SERVICE DEPARTMENT FOR ASSISTANCE AND RECOMMENDATIONS FOR YOUR SPECIFIC APPLICATION.
PERMATEX, INC., HARTFORD SQUARE NORTH, 10 COLUMBUS BOULEVARD, HARTFORD, CT 06106 PHONE – (1-87PERMATEX)
Permatex is a trademark of Illinois Tool Works, Inc. ©2008 ITW Permatex, Inc. All rights reserved.
PRODUCT DESCRIPTION
Permatex

Ceramic Extreme Brake Parts Lubricant is a
purple, environmentally friendly, non-melting, pure synthetic
lubricant base formula. It is formulated to lubricate under the
most adverse brake conditions, assuring that critical caliper
pins, sleeves, bushings and pistons remain lubricated
throughout pad life. Contains ceramic solids for extreme
performance under the most critical braking parameters.
Permatex

Ceramic Extreme Brake Parts Lubricant, with its
water and corrosion resistant properties, is excellent on rolling
and sliding surfaces operating in wet or dry conditions from -
50F to +3000F (-46C to +1649C). It is compatible with
internal and external brake rubber and plastic hardware,
including ethylene-propylene rubber.
PRODUCT BENEFITS
 Temperature range -50F to +3000F (-46C to +1649C)
 Prevents disc brake squealing and chattering
 Prevents long bolt and sleeve seizing and galling
 Outperforms ordinary caliper greases and traditional disc
brake quiet products
 Non-silicone, non-petroleum based formula
 100% synthetic lubricant, environmentally safe
TYPICAL APPLICATIONS
 Long and short bolts
 Sleeves
 Bushings
 Outboard pad backing plate
 Inboard pad backing plate
 Disc brake calipers
 Caliper pins
 Pistons
DIRECTIONS FOR USE
1.
Wire brush the caliper housing and anchor plate to
remove all dirt and dust.
2.
Clean all parts with Permatex

Brake & Parts Cleaners.
3.
Apply Permatex

Ceramic Extreme Brake Parts
Lubricant to all moving caliper hardware, mating
surfaces and steel backing plates of the disc brake
pads.
4.
Lubricant may be applied to the BACKS of brake pads
to act as a noise suppressor eliminating caliper brake
squeal and chatter.
5.
Any excess grease that squeezes out from the mating
surfaces should be removed.
Note: Keep lubricant off pads and rotors.
PROPERTIES OF MATERIAL
Typical Value
Chemical Type
Synthetic base oil
Appearance
Purple paste
Specific Gravity
0.95
Worked penetration (60 strokes),
ASTM D-217
265-295
Dropping point, ºC (ºF) ASTM D-2265
None
NLGI Number
2
Rust Preventative Test ASTM D-1743
Pass
Water Washout @100F, % Loss,
ASTM D-1264
2.0
Timken OK Load, lbs. , ASTM D-2509
45
Four-Ball Wear Scar, mm (40 kg. 1 hr
1200 RPM) ASTM D-2266
0.6
GENERAL INFORMATION
This product is not recommended for use in pure oxygen
and/or oxygen rich systems.
For safe handling information on this product, consult the
Material Safety Data Sheet, (MSDS).
ORDERING INFORMATION
Part Number
Container Size
24124
14g (2-7g pouches)
24125
8 fl oz brush-top bottle
STORAGE
Products shall be ideally stored in a cool, dry location in
unopened containers at temperatures from 8 and 28C
(46 and 82F) unless otherwise labeled. Optimal storage is at
the lower half of this temperature range. To prevent
contamination of unused product, do not return any material to
its original container.