Specifications

6
2
22
2 Instant Install
If you are like us, the first thing you will want to do is to play
your favourite piece of music through your new SX25. The
following instructions are written to enable you to achieve this as
quickly as possible. These are not comprehensive instructions,
but are designed to enable you to play music now!
Note:
Please take the time to read the SX25 manual thoroughly
as it incorporates many features, which will enhance its
operation.
Placement
The SX25 is a convection cooled amplifier and best results will
be achieved when placed on a solid surface with adequate
ventilation. DO NOT place on a carpeted floor or cover the
amplifier!
Place the SX25 close or near the source component in order to
make as short a connection as possible.
Turn off associated components
This minimises the potential to damage any other components
when connecting your SX25 into the system.
Connect source to preamplifier
Connect the audio output from the source component to the input
of your preamplifier.
Connect preamplifier to SX25
Connect the audio output from your preamplifier to the inputs at
the rear of the SX25. Refer to Chapter 4 for Rear Panel
information.
Connect loud speaker cables to SX25
Connect your left and right channel loudspeaker leads to the
speaker binding posts at the rear of the amplifier. Refer to
Chapter 4 for Rear Panel information.
Note:
Make sure the nominal impedance of the loudspeakers is
not lower than 2Ω.