Specification Sheet

ManualsBrandsPerrin and Rowe ManualsPlumbingBrass Floor Pillar Legs for Tub Fillers

U.6388

FEATURES COLORS/FINISHES WARRANTY

www.rohlhome.com

• 1/2" female NPT connection

• Integrated shut-off valve

• Separate rough and trim

• U.6399 3” extension unions available

to lift height of filler valve

• Polished Chrome

• Polished Nickel

• Satin Nickel

• Inca Brass

• English Bronze

• Limited Lifetime

ROHL Perrin & Rowe

Bath

PAIR OF FLOOR SUPPLY UNIONS FOR EXPOSED TUB FILLERS

Ø3

/4 " 1/2" NP T

4" c enters

G3/4"

/2 "

Access to

Shut-off valve

Consult your local ROHL showroom for additional information and specifications. For complete warranty details and a list of showrooms, go to www.rohlhome.com.

Summary of content (5 pages)

PAGE 1
www.rohlhome.com PAIR OF FLOOR SUPPLY UNIONS FOR EXPOSED TUB FILLERS ROHL Perrin & Rowe® Bath U.6388 FEATURES COLORS/FINISHES WARRANTY • • • • • • • • • • Limited Lifetime 1/2" female NPT connection Integrated shut-off valve Separate rough and trim U.
PAGE 2
www.rohlhome.com U.6388 Spare Parts 9.061153 Screws x4 9.24811* Consult your local ROHL showroom for additional information and specifications. For complete warranty details and a list of showrooms, go to www.rohlhome.com.
PAGE 3
www.rohlhome.com U.6388 Installation Guide Page 1 Ø 3 1/4” Consult your local ROHL showroom for additional information and specifications. For complete warranty details and a list of showrooms, go to www.rohlhome.com.
PAGE 4
www.rohlhome.com U.6388 Installation Guide Page 2 Fit a 3/4” plug to leak test the installations Install stop valve onto NPT connector with slotted screw facing the rear of the installation, fully tighten bottom nut. Check that slotted screw has remained in position. The rough line should be tested by using the in-line isolating valve. It is recommended to fit a 3/4” plug to leak test the Supply Flex and joint.
PAGE 5
www.rohlhome.com U.6388 Installation Guide Page 3 Slide outer tube over the Supply Flex with the Access Slot aligned with stop valve screw. Ensure the top nut remains accessible Supply flex nut Loosely fit the outer tube to mounting surface with 4 fixing screws. Slide rosette over outer tube and place on top of floor leg flange. Holding the nut on supply flex, thread on the union. Avoid twisting supply flex. The mixer can now be fitted using the installation instructions supplied.