Instruction Manual

Parts List Required Tools (not included)
Item Qty. Description Qty. Description
A 2 Bed Rail 1 7/32” Allen Wrench
B 4 3/8” x 2” Allen Head Bolt
C 4 3/8” Nylon Washer
D 4 Neoprene Rubber Plate Gasket
E 4 Rectangular Threaded Tap Plate
visit our website at www.perrycraft.com
by
STAKE-POCKET MOUNT
INSTALLATION INSTRUCTIONS
1. Before beginning the installation, please review this installation sheet carefully, insuring that all
necessary hardware is included. If any parts are missing, please contact Perrycraft, Inc immediately.
2. Assemble fastening components on both ends of each rail as shown on diagram below (including
Threaded Tap Plates on end of bolt), then place the bed rail over the stake pocket holes.
3. Attach the bed rail by inserting the Tap Plate into the stake pocket hole. As the Allen Head Bolt is
turned clockwise, the Tap Plate will spin around and lock itself inside the stake pocket hole.
4. Repeat Step 5 for each remaining corner fastening point.
5. Frequently check all fasteners and tighten as necessary.
Perrycraft, Inc. 2804 Griffith Road Winston-Salem, NC 27103 800-777-7081
Stainless Steel Tubular Rails
INHDS-STKPKT 121108
A
B
C
E
D
Product Installed
Diagram
CLEANING AND MAINTENANCE INSTRUCTIONS: To maintain and care for this product, please keep
it clean and do not use abrasive cleaners or polish waxes. Automotive waxes such as pure Carnuba
are recommended to remove scratches.