For The ON-THE-GO Pet™ INSTRUCTION MANUAL ULTRA LITE PET STROLLER PG8030IB Interior Dimensions: 22L x 11W x 16H To see our full line of products, visit us online at: www.petgearinc.com CUSTOMER SERVICE HELP DESK customerservice@petgearinc.
PARTS LIST Check that you have all the parts shown BEFORE assembling your product. If any parts are missing, call Customer Service. OPENING THE STROLLER Step 1. Release locking latch 2 Step 2. Unfold as shown. Make sure both locks snap into place.
TO ASSEMBLE FRONT WHEELS Step 1. Turn stroller over as shown. Step 2. Push wheel assembly onto stroller leg until it snaps into place. Step 3. Repeat for other wheel. Tug firmly on each wheel assembly to be sure wheels are securely in place. Note Direction of Arrow NOTE: To remove, squeeze tab and pull wheel off. TO ASSEMBLE REAR WHEELS Step 1. Remove and discard protective sleeve from ends of rear axle assembly and rear leg tubes. Step 2. Position rear axle assembly onto rear leg tubes at the same time.
TO ASSEMBLE REAR WHEELS Step 3. Slide wheel onto axle. Step 4. Slide washer onto axle. Step 5. Fit straight part of cotter pin through hole on axle. Step 6. Line up each of the tabs in the hub cap with the slots in the wheel. Snap hub cap into place. Fit cover to collet by firmly pressing the cover into place. Step 7. Repeat for other side. APPLYING THE BRAKES Step 1. Push levers on both rear wheels down to lock. Step 2. Pull levers up to unlock.
FOLDING THE STROLLER Step 1. Before folding the stroller, lock the brakes and close the canopy. Step 2. Standing behind the stroller, pull up on both side latches. Step 3. Fold as shown. Step 4. Engage locking latch. NOTE: Fold stroller so wheels straddle frame. DO NOT allow wheels to press against frame as this may damage tires.
LOOKING AFTER YOUR STROLLER • Always store product in a clean, dry place. • Not recommended for use on the beach. • Do not put heavy items on top of the stroller. • Clean frame by wiping with a lightly oiled cloth. • Do not use detergent or abrasives. Spot clean fabric with dry cleaning fluid or mild soap and warm water. • To ensure easy maneuverability and to minimize wear and tear, (especially wheels, axles, and swivels), keep all moving parts clean and lubricated with WD40® or light machine oil.
WARNING! FOR PETS ONLY. Not intended to be used as a restraining device for aggressive or dangerous animals that dig, chew or paw aggressively. Do not leave your pet unattended. PET GEAR is not liable for any damage caused by aggressive, destructive, immature or untrained animals. Do not use near an open or exposed flame. Failure to follow these warnings and the instructions could result in serious injury or death.