User's Manual

DIGITAL GIVE & BOOST

The motor as a default runs in constant mode which means the stitching speed is not

affected by the skin’s resistance.

Enabling give will allow the machine to respond to the skin’s resistance and become

softer. By choosing between 3 levels of give you can adjust the sensitivity and softness.

GIVE-1 is subtle and allows for easier shading, GIVE on the 2nd and 3rd level will make

the machine even softer and sensitive to the skin.

Choosing the best option is subjective. You should experiment and pick the one that works best for you.

Long press the DOWN button to enable GIVE (GVE #). Long press again to disable.

Enabling boost will allow the machine to run without dropping the stitching speed but

it will actually respond to the skin’s resistance on difficult areas and become punchier

and faster to ensure optimal results.

Long press the UP button to enable BOOST (BST). Long press again to disable.

PAIRING WITH THE PILOT FOOTSWITCH

In order to pair the Force pen with the Pilot Wireless Footswitch, do the following:

1. Long press the ON/OFF button to enter the Settings menu.

2. Navigate to Footswitch using the UP and DOWN arrow keys.

3. Press the + button to enter the Footswitch sub-menu and press the + button again

to start the pairing process.

4. Press the Footswitch 5 times and you will see a successful pairing message on the

screen.

5. Press the ON/OFF button to exit and start working with the Footswitch.

In order to change from TOGGLE to HOLD and vice versa, go back to the Settings menu,

below the Footswitch you can now find the Footswitch Modes sub-menu.

SETTINGS MENU

While in the settings menu, navigate using the UP and DOWN buttons, change values using the + and -

buttons and accept using the + button. Press the ON/OFF button once to exit.

1. GIVE: Choose between 3 levels of sensitivity.

2. INCREMENT: Choose between 0.1 - 0.3 - 0.5 voltage increments/decrements.

3. FOOTSWITCH: Pair/Unpair the PILOT Wireless Footswitch.

3a. FOOTSWITCH MODE: Choose between TOGGLE or HOLD mode.

4. MOTION CONTROL: Enable/disable Motion control.

5. ENABLE BLE: Enable/disable Bluetooth connectivity.

6. SOUND: Turn indication sounds on/off.