Product Manual

11
petsafe.com
Set the Static Correction Level
Read all steps before attempting to set the static correction level.
1. Press the mode button and release (3B) when the receiver indicator light illuminates red (3C).
2. The receiver indicator light will emit a series of red flashes representing the static correction level.
3. Increase the static correction level by pressing and releasing the mode button within 5 seconds of the previous
series of flashes.
The static correction levels increase in strength from 1 to 6. Pushing the correction level button while the receiver collar is
on level 6 will cause the receiver collar to revert to level 1. Refer to the function and response table to choose the static
correction level that best fits your pet.
Function and Response Table
Indicator Light Response Static Correction Level Receiver Collar Function
1 red flash 1 No static correction, Tone-only
2 red flashes 2 Low static correction
3 red flashes 3 Medium-low static correction
4 red flashes 4 Medium static correction
5 red flashes 5 Medium-high static correction
6 red flashes 6 High static correction
Over Correction Protection
If your pet enters the boundary zone or continues anywhere beyond the pet area, this feature limits the static
correction duration to 15 seconds. While the system locks out further static correction, the green light will remain on for
10 seconds.
In the unlikely event that your pet leaves the pet area, he will not receive a static correction upon return to the pet area.