Product Manual

12
[phone]
Step 4: Adjust the Pet Area to Desired Size
Make sure the entire pet area lies within your property boundaries (4A). Always start determining the boundary zone
at the shortest distance from transmitter. Place the boundary switch on “Low” if the boundary zone will be less than
45 feet from the transmitter.
Test Light Instructions
1. Make sure the receiver collar battery is properly charged.
2. Set the correction level to 2 or above.
3. Hold the test light contacts to the contact points. (4B)
4. Walk toward the boundary zone holding the receiver collar about waist high until the test light flashes ( 4C ).
Save the test light for future testing.
Note: If your next-door neighbor has a containment system, see the troubleshooting section page 18.
To maximize your pet area, make sure the boundary switch is on “High” and the boundary control dial is set to “8”. Plug
the power adaptor into the power jack and a standard 120 volt outlet.
Two-Person Method
Hold the receiver collar about waist high with logo side facing away from the transmitter and contact points facing
upwards. Walk to the edge of the desired pet area. Facing away from the transmitter, hold the receiver collar at the
edge of the desired pet area (4C).
Starting with the boundary control dial set to “8”, have a second person turn the dial down SLOWLY. When the
receiver collar tone starts, tell the person to stop turning the boundary control dial. Walk back into the pet area until the
receiver stops sounding. Verify the pet area boundary by walking towards the boundary zone and verifying that the
tone/test light flashes begin at the desired location. Test at multiple locations around the pet area to verify the pet area
is within your desired location. Record your settings on page 13 for future reference.
One-Person Method
Measure the shortest distance from the desired boundary zone to the transmitter. Find the distance on the transmitter range
chart on page 13 and set the boundary switch and boundary control dial. Hold the test light contacts to the contact
points (4B). Take the receiver collar to the boundary zone with the logo side facing away from the transmitter and contact
points facing upwards (4C). Hold the receiver collar about waist high until the receiver collar tone sounds and the test light
flashes. If the receiver collar tone sounds before or after the desired boundary zone, return to the transmitter and adjust
the boundary control dial. Repeat this process until the receiver collar tone sounds at the desired location. Record your
settings on page 13 for future reference.
Pet
Area
B
o
u
n
d
a
r
y
Z
o
n
e
Pet Area
Street
4A 4B
4C