Product Manual

15
petsafe.com
To assure a proper fit, please follow these steps:
1. Make sure transmitter is not plugged in, and the receiver is turned off.
2. Start with your pet standing comfortably (6A).
3. To make it easier to hear the warning beep, place the receiver collar on your pet with
the logo side of receiver facing your pet’s chin.
4. Center the contact points underneath your pet’s neck, touching the skin.
You may need to trim the hair in the area of the contact points. Never shave the dog’s neck; this may
lead to a rash or infection.
5. Check the tightness of the receiver collar by inserting one finger between the end of a contact point and your pet’s
neck. The fit should be snug but not constricting (6B).
a. Allow your pet to wear the collar for several minutes then recheck the fit.
b. Check the fit again as your pet becomes more comfortable with the receiver collar.
6. Trim the collar as follows (6C):
a. Mark the desired length of the receiver collar with a pen. Allow for growth if your pet is young or grows a thick
winter coat.
b. Remove the receiver collar from your pet and cut off the excess.
c. Before placing the receiver collar back onto your pet, seal the edge of the cut collar by applying a flame along
the frayed edge.
Re-Thread the Collar
6A
6C6B
The slide buckle prevents the collar from
becoming loose around your pet’s neck. The
ridges must be facing up; the collar will slip if
it is not properly threaded.
To loosen: Slide the strap through
the slide buckle and fasten buckles
and pull down.
To tighten: Slide the strap up through the fasten
buckle and pull through the slide buckle.
Slide
Buckle
Slide
Buckle
Fasten
Buckle
Ridges