Installation Guide

8 Customer Care Center 1-800-732-2677

Operating Guide

Step 1

Prepare the Handheld Remote

To Insert and Remove the Batteries

1. Slide off the battery cover (1A).

2. Install two (2), 3-volt (CR2032) batteries positive (+) side up (1B).

3. Slide the battery cover back in place (1C).

To verify the batteries are inserted correctly

1. Press any button on the Handheld Remote.

2. The Remote LED should ﬂash to indicate a button has been pressed.

3. If the Remote LED doesn’t ﬂash, you may have inserted the batteries backwards. Try taking them out

and turning them over, ensuring that the (+) side is up.

4. If the

Remote LED

still does not ﬂash, contact the Customer Care Center.

Risk of explosion if batteries are replaced by an incorrect type. Do not short circuit, mix

old and new batteries, dispose of in ﬁre, or expose to water. When batteries are stored

or disposed, they must be protected from shorting. Dispose of used batteries properly.

Handheld Remote LED - Function and Response

Handheld Remote Function LED Response

Any button pressed On for length of button press

Low battery condition LED ﬂashes 3 times every 5 seconds

1C1A 1B