Installation Guide

www.petsafe.net 7

Install Pet Door

Before putting away the jigsaw, place the interior frame (frame with the ap) inside the

cut out and check the t. Then, place the exterior frame into the underside of the door to check

the t. If frames do not t inside the opening, you may need to recut to square opening before

proceeding with installation.

Helpful Tip: Tape the ﬂap up to keep it out of the way during the installation.

5A.

Place interior frame (frame with ap) into cutout.

Next place exterior frame into cutout from

underside of door, aligning core covers into tabs

of frame. Hold frame together with one hand.

5B.

Drop nylon screws through holes in frame then

thread hex nut to bottom of each screw. While

continuing to hold frames, tighten screws until

frames come together.

Optional:

Caulk around the exterior frame

(frame without the ap) and inside threshold

where core covers meet for weather resistance.

5C.

Use a screwdriver to evenly tighten screws throughout frame

while keeping core covers in position. It may be necessary to

adjust screws to make sure pet door t is correct.

5D.

Cut off excess screws length with wire cutters. Hold wire

cutters ush with frame for a clean, level cut.

Use a manual screwdriver to tighten the

screws. Do not overtighten. Overtightening

can strip the thread off the screws or bow

the pet door frame.

Train Your Pet

6A.

Rehang your door and begin training your pet. Tape the ap open

to help your pet become familiar with the opening.

Helpful Tip: Try treats to encourage your pet to go through the pet

door and become comfortable using it.

Step 5

Optional

Step 6