INNOTEK® UltraSmart™ In-ground Pet Fencing Systems Invisible Technologies, Inc. 1-800-826-5527 www.innotek.
INNOTEK® UltraSmart In-ground Pet Fencing Systems About Your INNOTEK® UltraSmart™ Discover what a difference an in-ground fencing system can make. You’ll discover the ease and convenience of keeping your dog safe in your yard without the structure and expense of traditional fencing. Lightning Protection is an important part of your system. This module is connected between the loop wire and the transmitter.
Quick Start Guide (continued) Step 5 IUC-4100, IUC-4200, IUC-5100, IUC-5200 collar light Charge Collar Choose a location close to a door that you and your dog use regularly and plug in the wall charger. Position the collar in the charging cradle. The collar fits in the cradle with the collar light to your left and with the contacts that touch your dog’s skin facing down.The collar’s light glows red while charging, green when charging is complete. Step 6 Test Your Fence Page 8 1.
INNOTEK® UltraSmart™ In-ground Pet Fencing System 2. Field Size Switch – Set switch to small (SM) for installations of 1,000 feet of wire or less. 3. Stimulation Level Switch – Select from levels Low, Medium, or High, the correction level your dog will feel after the 2-second warning tone (LOW and MED selections only). The tone and correction occur at the same time when level is set on HIGH. 4. Loop Wire Terminals – Spring-loaded connections for the pet fencing wire. 5.
For your dog’s safety, we recommend keeping the pet fencing wire at least 10-feet from the street. Keep in mind that you will want to place the wire where there is room for an 812 foot pet fencing field from the buried wire. Step 2 Front and Back Yard Loop. The most common installation. The wire is placed just inside the property line to form a square or rectangle. splices Install the Wall-mount transmitter Work carefully.
ReadyTest™ feature When you remove the collar from the charging station, the unit will automatically go into self-test mode for about 8 seconds. The collar’s internal diagnostics will check that the battery charge is full and that all circuits are working correctly. Do not touch the skin contacts during this test. Ready Test gives you added confidence that your pet fencing collar is working and ready to go.
your transmitter. Continue to hold DOWN arrow button through the end of the next step. NOTE: You cannot reprogram the collar if the Zone is set on A/B mode. 3. Press and release the UP arrow button until desired mode is indicated. Now press and hold the UP arrow button until one bar segment appears, followed by three beeps from the collar. The collar is now set for your chosen mode. 4. Important: Any collar that is within 6 feet of the transmitter and turned on will be reprogrammed by these steps.
BOOST Pressing the button sends a continuous signal to the collar, raising the stimulation by 2 levels. For example, if the control stimulation level is set at Level 3, a touch of the will correct at Level 5 . Some trainers like instant access to a higher setting for circumstances with high distractions. B B Tone button sounds a tone in the collar. No stimulation is The delivered when this button is pressed. The tone continues for as long as the button is held down.
