Quick Start Guide PWW00-16928 PetSafe Drinkwell® Butterfly Pet Fountain Please read this entire guide before beginning.
Welcome You and your pet were made for each other. Our aim is to help you have the best companionship and the most memorable moments together. Your new pet fountain is designed to entice your pet to stay hydrated and healthy. We know that safe pets make happy owners. Before getting started, please take a moment to read through the important safety information. If you have any questions, please don’t hesitate to contact us.
• Do not allow pets to chew on or swallow any parts. If you are concerned your pet may chew the power cord, purchase a cord conduit (a hard plastic protector) at any hardware store. • The plastic fountain parts are BPA-FREE. However, some animals have been known to be sensitive to plastic food and water containers. If your animal shows signs of an allergic reaction to the plastic, please discontinue use until you have consulted with your veterinarian.
In the Box Butterfly Topper Upper Tray Filter Housing Top Filter Housing Base Carbon Filter Bowl Foam Filter Pump Adaptor 4 Customer Care Center +1 (800) 732-2677
1 Assemble Pet Fountain Note: Rinse all fountain components (except for the adaptor) with warm water before using the pet fountain. This will remove any residue from the manufacturing process. 1. Take the pump apart by first removing the blue faceplate. Use your finger to pull up on the small tab. 2. Remove the teardrop shaped stator by pulling up on the small lip. 2 3. Use a fingernail to pull out the impeller, which is held in place magnetically. Clean the pump parts with warm water and soap.
5. Place the pump and foam filter into the bottom of the bowl inside the square indentation as shown. Press down to engage the suction cups. Note: Wetting the suction cups will ease assembly. 5 6. Once the pump and foam filter are securely in place, feed the cord through the raised post and out the notch on the base of the bowl. 7. Remove the extra slack from the cord and push the rubber seal firmly into the raised post. (Refer to image #6) 6 8.
10 10. Pour water into the bowl until it reaches the MAX (maximum) fill line. 11. Attach the upper tray to the bowl by aligning it over the filter housing. Press down on both sides to secure the locking tabs. Note: The water outlet on the tray will face the back of the bowl. The PetSafe® logo indicates the front of the bowl. 11 Water Outlet Locking Tab 12. Insert the butterfly topper into the hole on the top of the tower. This will provide your pet with four water streams to drink from.
Pet Fountain Cleaning NOTE: Replace the carbon filter every 2-4 weeks and replace the foam filter every 1-2 months. 1. 2. 3. 4. Unplug the fountain and disconnect the in-line plug. Pick up the pet fountain by the bowl and take it to the sink. Pour out the water, and then disassemble the pet fountain. Discard the carbon filter and the foam filter. See steps 1-3 on page 5 for cleaning your pump. Use a solution of 80% water and 20% white vinegar to remove hard water buildup. 5.
Terms of Use and Limitation of Liability 1. Terms of Use The use of this product is subject to your acceptance without modification of the terms, conditions and notices contained with this product. Use of this product implies acceptance of all such terms, conditions, and notices.
