Quick Start Guide PWW00-16790 PWW00-16777 PWW00-16468 Drinkwell® ½ Gallon Pet Fountain Drinkwell® 1 Gallon Pet Fountain Drinkwell® 2 Gallon Pet Fountain Please read this entire guide before beginning.
Welcome You and your pet were made for each other. Our aim is to help you have the best companionship and the most memorable moments together. Your new pet fountain is designed to entice your pet to stay hydrated and healthy. We know that safe pets make happy owners. Before getting started, please take a moment to read through the important safety information. If you have any questions, please don’t hesitate to contact us.
• Do not allow pets to chew on or swallow any parts. If you are concerned your pet may chew the power cord, purchase a cord conduit (a hard plastic protector) at any hardware store. • The plastic fountain parts are BPA-FREE. However, some animals have been known to be sensitive to plastic food and water containers. If your animal shows signs of an allergic reaction to the plastic, please discontinue use until you have consulted with your veterinarian.
In the Box Foam Filter Pump Rubber Seal (attached to the pump) Filter Housing Base Filter Housing Top Lid Carbon Filter Flow Control Knob Tower Connector Tube Side B Connector Tube Side A Bowl Adaptor 4 Customer Care Center +1 (800) 732-2677
Lid Flow Control Knob Tower Connector Tube Side A Connector Tube Side B Filter Housing Top Carbon Filter Filter Housing Base Pump Foam Filter Rubber Seal Bowl Adaptor petsafe.
Assemble Pet Fountain 1 Note: Rinse all fountain components (except for the adaptor) with warm water before using the pet fountain. This will remove any residue from the manufacturing process. 1. Take the pump apart by first removing the blue faceplate. Use your finger to pull up on the small tab. 2. Remove the blue teardrop shaped stator by pulling up on the small lip. 2 3. Use a fingernail to pull out the impeller, which is held in place magnetically.
5. Insert the filter housing into the hole on top of the pump. 5 6. Place the assembled pump and filter housing into the foam filter with the cord running above it. 6 7. Place the assembled pump, filter housing and foam filter into the bottom of the bowl as shown. Press down to engage the suction cups. Note: Wetting the suction cups will ease assembly. 7 8. Once the pump is securely in place, feed the cord through the hole on the back of the bowl and out the notch on the bottom of the bowl.
9. Remove the extra slack from the cord and push the rubber seal firmly into the hole. 9 10. Open the connector tube by using the tabs to pull it apart. Rinse both sides under water. 10 11. Close the connector tube by aligning the clips from the bottom and pressing down until it snaps shut. 11 12. Insert the connector tube into the hole on the top of the filter housing as shown.
13. Attach the tower by aligning it with the raised notches on the back of the bowl. 13 14. Insert the flow control knob into the hole on the top of the tower. Turn the knob clockwise to maximize the water stream. Turn the knob counter clockwise to decrease the water stream or shut it off. 14 15. Attach the lid to the tower. Pick up the pet fountain by the bowl and place it in a desired location. Pour water into the bowl, leaving 1/2 inch of space between the water level and the rim of the bowl.
Pet Fountain Cleaning NOTE: Replace the carbon filter every 2-4 weeks and replace the foam filter every 1-2 months. 1. 2. 3. 4. Unplug the fountain and disconnect the in-line plug. Pick up the pet fountain by the bowl and take it to the sink. Pour out the water, and then disassemble the pet fountain. Discard the carbon filter and the foam filter. See steps 1-3 on page 6 for cleaning your pump. Use a solution of 80% water and 20% white vinegar to remove hard water buildup. 5.
Terms of Use and Limitation of Liability 1. Terms of Use The use of this product is subject to your acceptance without modification of the terms, conditions and notices contained with this product. Use of this product implies acceptance of all such terms, conditions, and notices.
Radio Systems Corporation 10427 PetSafe Way Knoxville, TN 37932 +1 (800) 732-2677 petsafe.
