Manual

4 1-800-732-2677
Interior Wall Cut-Out
1. Locate the site for the Wall Entry Aluminum Pet
Door.
2. Locate the studs in the proposed area.
3. Locate the center between the two studs. Using a
pencil, draw a 5" vertical line on center about 10"
to 12" above the fl oor (1A).
Note: Check for electrical and plumbing fi xtures
that could be in the wall where you wish to place the
Pet Door.
4. Mark the shoulder height of your pet on the
vertical line. Draw a horizontal line through
your mark (1B).
5. Place the template against the wall; align the lines
on the template with the lines on the wall. Tape in
place. Check that the template is square (1C, 1D).
6. Carefully trace the template with a pencil (1E).
Remove the template from the wall.
7. Take a moment to review the hole location to
ensure that the template is level and that this is
the best possible location for the Pet Door.
10"-12"
Center Between
Studs
Shoulder Height
1A
1B
1C
1D 1E
Step
1