Operation Manual

Acc ess
86
3008-2_en_Chap02_ouvertures_ed01-2016
Operating the sunroof blind
Opening
F Press and hold the rear of button A, without
going beyond the point of resistance; the
blind opens and stops when you release
the button.
During simultaneous closing of the
sunroof and the blind, if the blind
catches up with the sunroof, the
blind then suspends its movement
and automatically resumes when the
sunroof stops.
The closing movement of the blind is limited by
the position of the opening sunroof: the blind
cannot be further forward than the front of the
mobile glass.
Closing
Any new action on this button interrupts the
movement.
Anti-pinch system
If the blind encounters an obstacle when
closing, the movement is automatically
reversed.
Reinitialisation
Following reconnection of the battery or in the
event of a fault or jerky movement of the blind,
the blind must be reinitialised:
F press the rear of button A until the blind is
fully open,
F press and hold the rear of button A again
for at least 3 seconds.
F Press the rear of button A going
beyond the point of resistance to
fully open the blind.
Any new action on this button interrupts the
movement.
F Press the front of button A,
going beyond the point of
resistance to fully close the
blind.
F Press and hold the front of button A,
without going beyond the point of
resistance; the blind closes and stops
when you release the button.