Operation Manual

Practical information
224
F Detach the wheel/box assembly from the
rear of the vehicle.
F Straighten the wheel for acces to the tool
box.
F Remove the link piece from the lid of the
tool box, as shown in the illustration.
F Pass the link piece through the hub of the
wheel.
F Place the extension 7 onto the spare wheel
carrier drive nut.
F Fit the wheelbrace 6 to the end of the
extension 7.
F Turn the assembly fully clockwise to
unwind the carrier cable, until the spare
wheel is resting flat on the ground.
When the spare wheel is fitted in place
of a wheel with a punctured tyre, it is
essential to return the carrier and tool
box to their position under the vehicle,
before moving off.
Refer to the "Putting the carrier and
spare wheel back in place" section.