User Manual

BEFORE LOADING AND PLUGGING IN THE WINE COOLER

Before using your wine cooler

• Remove the exterior and interior packaging.

• Before connecting the wine cooler to power source, let it stand upright for approximately 6 hours. This

will reduce risk of a malfunction in the cooling system from handling during transportation.

• Clean interior surface with lukewarm water by using a soft cloth.

• When replacing the illuminating lamp, please select a lamp similar to the original. Shut off the power

supply before replacing the lamp.

Installation of your wine cooler

• Place your wine cooler on a surface strong enough to support it when fully loaded. Level your wine

cooler by adjusting the levelling legs at the bottom front of the wine cooler.

• Place the wine cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct

sunlight may affect the acrylic coating and heat sources may increase energy consumption.

• Extreme cold ambient temperatures may also cause the unit not to perform properly.

• Avoid locating the unit in moist areas.

• Plug the wine cooler into a properly installed wall outlet with an earth/ground connection plug. Any

questions concerning power should be directed toward a certified electrician or an authorized products

service center.

Pay attention to this

• Store wine in sealed bottles.

• Do not overload the wine cooler.

• Do not open door unless needed.

• Do not cover shelves with aluminium foil or any other material that may prevent air circulation.

• Should the wine cooler be stored unused for a longer period of time, it is advised, after a good cleaning,

to leave the door ajar to allow air to circulate inside the cabinet in order to avoid possible formation of

condensation, mold or odours.

• The carbon filter should be cleaned and dried at least once a year.

LEVELLING THE WINE COOLER

ALL wine coolers must be levelled before loading with wine.