User Guide

Adjustment

12 - 26

12.05.24 Presser foot to needle plate clearance

Requirement

When the hand lever is raised, the needle should penetrate exactly in the

"needle hole

centre"

of the presser foot and the presser foot to needle plate clearance should be

7 mm.

● Set the zigzag stitch adjustment lever at

"0"

and the stitch position adjustment lever at

"centre".

● Let the presser foot drop onto the needle plate and reduce the pressure on the presser

bar by turning screws

● Place the feed dog adjustment gauge under the presser foot with the recess at the

bottom.

● Loosen screw

and raise hand lever

● Allow the needle to penetrate the needle hole and align the presser foot in accordance

with the

requirement.

● Press the presser bar lifting piece down and tighten screw

Fig. 12 - 25

81-036

81-038

5 mm