User Guide
Adjustment
12 - 40
12.07.03 Position of the thread catcher and cutting test
Requirement
When the thread trimmer is in its neutral position, the edge of thread catcher
6
should be
flush with the edge of the mounting plate
4
.
92-044
3
3
1
2
4
6
Fig. 12 - 39
● Turn linkage rod
1
(nuts
2
, left and right thread) in accordance with the
requirement.
● During the cutting test, remove linkage rod
1
, loosen screws
3
and remove mounting
plate
4
.
● Carry out the cutting test with double thread.
● By turning screw
5
adjust the cutting pressure.
● Fit mounting plate
4
so that its edge is flush with the edge of the bed-plate.
● Tighten screws
3
and replace linkage rod
1
.
81-100
5