Operation Manual

If the needle thread breaks or runs out the machine
stops
after max.
6
stitches and elicits the message:
Attention: Needle
thread is broken or
supply is empty
ok?
To resume
embroidering
at
the position
at
which
the thread breakage occurred, press number key 9
and press the toot pedal. The
machine
now skips
back
6
stitches. You can repeat this procedure as
often as
you
wish. Then thread the needle thread
and and press the foot pedal. By
pressing
the ok
key the machine finishes embroidering the pattern
automatically.
The bobbin thread supply
display blinks
when the
bobbin thread is running low. The machine stops
and this message
appears
in
the display:
Bobbin thread running low
ok?
You can continue sewing if you think that the
bobbin thread is sufficient for the rest
of
the
section, however the bobbin thread supply display
continues
to
blink. The display remains lit until
a
full bobbin has
been inserted
and
you
continue
to
sew.
• Sewing foot lifter
The sewing toot lifter must be brought to embro
idery position before beginning
to
embroider. If
it
is
not,
the machine will not sew when you press the
foot pedal
and
the message
appears:
Bring sewing foot lifter to
embroidering/darning position
ok?
• Lower feed
dog
If the feed
dog is not
lowered for
embroidering, the
machine does not embroider when the foot pedal
is pressed and the
message appea rs:
Lower feed dog
ok?
The
feed
dog must be lowered in embroideri
mode.
Error messages in embroidery mode
• Needle thread broken
or
empty • Check the bobbin
thread
I:
I
ii
I
I
I
29