SDS
SAFETY DATA SHEET
Organic Bonded Abrasives, Type 2 (1/13)
SDS #11
Page 4 of 7
and/or Calcium
Carbonate
15 mg/m
3
(total
dust)
5 mg/m
3
(respirable)
None Established
None Established
10 mg/m
3
and/or Manganese
Dichloride (as Mn)
5 mg/m
3
Ceiling
0.2 mg/m
3
0.2 mg/m
3
5 mg/m
3
and/or Polyethylene
None Established
None Established
None Established
None Established
and/or Manganese
Carbonate (as Mn)
5 mg/m
3
Ceiling
0.2 mg/m
3
0.2 mg/m
3
5 mg/m
3
and/or Calcium
Fluoride (as F)
2.5 mg/m
3
2.5 mg/m
3
2.5 mg/m
3
2.5 mg/m
3
and/or Fleece
None Established
None Established
None Established
None Established
and/or Adhesive,
cured
None Established
None Established
None Established
None Established
Graphite
15 mppcf (natural)
15 mg/m
3
(total
dust)
5 mg/m
3
(respirable)
(synthetic)
2 mg/m
3
(respirable)
2 mg/m
3
2 mg/m
3
Paper
15 mg/m
3
(total
dust)
5 mg/m
3
(respirable)
10 mg/m
3
10 mg/m
3
10 mg/m
3
Note: Consider also components of base materials and coatings being ground.
Exposure Controls
Ventilation: Use local exhaust or general ventilation as required to minimize exposure to dust and maintain the
concentration of contaminants below the occupational exposure limits.
Respiratory Protection: Use an approved respirator if exposure limits are exceeded or where dust exposures
are excessive. Consider the potential for exposure to components of the coatings or base material being ground
in selecting proper respiratory protection. Refer to local regulations for specific standards where appropriate.
Selection of respiratory protection depends on the contaminant type, form and concentration. Select and use
respirators in accordance with applicable regulations and good industrial hygiene practice.
Gloves: Cloth or leather gloves recommended.
Eye Protection: Safety goggles or face shield over safety glasses with side shields.
Other: Protective clothing as needed to prevent contamination of personal clothing. Hearing protection may be
required.
9. PHYSICAL AND CHEMICAL PROPERTIES
Information on basic Physical and Chemical Properties
Appearance: Wheels, cut-off-, grinding- and cup wheels.
Odor: None Odor Threshold: Not Applicable
Boiling Point: Not Applicable Vapor Pressure: (mm Hg) Not Applicable
Solubility in Water: Insoluble Vapor Density: (Air = 1) Not Applicable
Specific Gravity: Not Determined Evaporation Rate: Not Applicable
pH: Not Applicable Octanol/Water Partition Coefficient: Not Available