Installation Guide

ENGLISH

7 8

8 TRIM FLANGE ATTACHMENT

Position Flange (8A) on Valve (8B) with Drain Hole (8C) at the bottom. Place

Protective Washer (8D) on the short end of the reversible Retainer Sleeve

(8E). Screw Retainer Sleeve (8E) onto threaded section of the Stem and

Bonnet (8G). Tighten Retainer Sleeve (8E) by hand until Flange (8A) is snug

to nished wall surface. If the short end of the Retainer Sleeve (8E) is too

short, reverse it to use the longer end.

9 FLOW FUNCTION HANDLE ATTACHMENT

With valve in “CLOSED” position, place and align Handle Hub (9A) onto

Cartridge Gears (9B). Be sure Lever (9C) is facing down. Secure with Set

Screw (9D).

7 TEMPERATURE ADJUSTMENT

Adjustment Gear (7A) is factory-set to prevent stem from reaching full hot

position. To determine if factory setting is satisfactory, turn on valve and rotate

Stem (7B) counterclockwise to full hot and test. If not, remove Adjustment Gear

(7A) with valve at full hot setting. To adjust valve to a colder setting, rotate Stem

(7B) clockwise or counterclockwise to a hotter setting (Use a thermometer for

measuring). Pster recommends a maximum temperature setting of 110°F

(43°C). Replace Adjustment Gear (7A) onto Stem (7B) by aligning the surfaces

of Valve Stop (7C) and Adjustment Gear Stop (7D) as shown. Once placed,

Stem (7B) should not rotate any further in the counterclockwise direction.

DECREASE

MAXIMUM

TEMPERATURE

Clockwise

Rotation

INCREASE

MAXIMUM

TEMPERATURE

Counterclockwise

Rotation

10A

10B