Installation Guide

ENGLISH

11 SPOUT INSTALLATION

Apply PTFE plumbers tape on both ends of Pipe Nipple (11A) (not included).

Screw Pipe Nipple (11A) into the elbow inside the wall and tighten with pipe

wrench. The Pipe Nipple (11A) is to project 3 ⅞” to 4” from the nished wall.

Screw Tub Spout (11B) onto Pipe Nipple (11A) and tighten until Spout is properly

positioned and ush to the nished wall.

10 SHOWER ARM INSTALLATION

Insert the longer end of Shower Arm (10A) through the Shower Flange (10B) .

Apply PTFE plumber’s tape to both ends of Shower Arm (10A) according to

manufacturer’s instructions. Screw the end of Shower Arm (10A) into pipe

elbow inside the wall. Slide Shower Flange (10B) tight to the wall.

12 UNIT START UP

Turn on hot and cold water supplies, and check all connections for leaks.

13 FLOW FUNCTION

By rotating the Lever Handle (13A) counterclockwise, the valve will be activated.

The water ow will increase by continuing to rotate the Lever Handle (13A).

14 TUB SPOUT FUNCTION

When the valve is turned on, water normally ows through the Tub Spout (14A).

To activate the shower, turn valve on and pull the Knob (14B) up. Hold on until

water ows continuously from the shower arm.

15 FINAL FLUSHING

For nal ushing, turn valve on and allow water to run through the Tub Spout

(15A) for several minutes. Pull Spout Knob (15B) up to allow water to run through

Shower Arm (15C). Allow water to run for several minutes until all foreign matter

clears the line.

16 SHOWER HEAD INSTALLATION

Thread Shower Head (16A) onto Shower Arm (16B).

Make sure Shower Head (16A) is securely tightened to Shower Arm (16B).

11A

”

to 4

”

11B

13A

CLOSED

OPEN

15B

14A

14B

For

Shower

15A

15C

16B

16A