Installation Guide

ENGLISH

TROUBLE SHOOTING TIPS

18 TEMPERATURE CONTROL

The temperature setting can be controlled by rotating Knob (18A) and aligning

the desired temperature reading with the Indicator (18B) on the Lever Handle

(18C). By rotating the Knob (18A) clockwise, the water temperature will

decrease to cold ow only. By rotating the Knob (18A) counter-clockwise, the

water temperature will increased to hot ow only.

17 TEMPERATURE CONTROL KNOB ATTACHMENT

With Temperature Stem (17A) set at full clockwise position, turn water on by

turning Handle Hub (17B) counterclockwise. Rotate Temperature Stem (17A)

counterclockwise to a set position until water temperature reaches and is

maintained at 100°F (Use a thermometer for measuring). Place and align

Temperature Knob (17C) onto Temperature Stem (17A) with 100°F marker

aligned with Handle Hub Indicator (17D). Secure with Screw (17E). Insert

Cover Button (17F) into Knob (17C).

Temperature or ow does not remain consistent.

The Cartridge Assembly (D) may need cleaning. Shut off water supply. Remove

Handle Assembly (A), unscrew Retainer Sleeve (B) and remove Flange (C) .

Remove Cartridge assembly (D) and inspect Cartridge (E) and inlets for debris

or sediment and ush with water. Reassemble whole unit and test. If problem

persists you may need to replace the Cartridge (E).

Dripping from either the tub spout or shower head.

Clean the Cartridge Assembly (D). Check to ensure the gasket (F) on the

back of the Cartridge (E) is in place. Reassemble cartridge, stem and bonnet

assembly and handle. Turn on the water and test. If the unit still leaks, replace

the Cartridge (E). Check Shower Head screen.

Make sure that both hot and cold water inlets are turned on.

Water ow is very low.

Check the Cartridge Assembly (D), for debris. Sediment where the water enters

the Shower Head (G) can also cause this symptom.

18A

17C

17D

FULL

HOT FULL

COLD

17C

17B

17A

17F

17E

18B

18C